Equalizer dbx2231

Input Connectors 1/4" TRS, female XLR (pin 2 hot), and barrier terminal strip Input Type Electronically balanced/unbalanced, RF filtered Input Impedance Balanced 40 kOhm, unbalanced 20 kOhm Max Input >+21dBu balanced or unbalanced CMRR >40dB, typically >55dB at 1kHz Output Connectors 1/4" TRS, male XLR (pin 2 hot), and barrier terminal strip Output Type Impedance-balanced/unbalanced, RF filtered Output Impedance Balanced 200 ohm, unbalanced 100 ohm Max Output >+21dBu balanced/unbalanced into 2 kOhm or greater; >+18dBm balanced/unbalanced (into 600 ohm) Bandwidth 20Hz to 20kHz, +/-0.5dB Frequency Response <10Hz to >50kHz, +0.5/-3dB Signal-to-Noise (NR In: +/-6 and +/-15dB ranges) >102dB, unweighted, ref: +4dBu, 22kHz measurement bandwidth Dynamic Range (NR In: +/-6dB and +/-15dB ranges) >120dB, unweighted Signal-to-Noise (NR Out: +/-6dB range) >94dB, unweighted, ref: +4dBu, 22kHz measurment bandwidth Dynamic Range (NR Out: +/-6dB range) >112dB, unweighted Signal-to-Noise (NR Out: +/-15dB range) >90dB, unweighted, ref: +4dBu, 22kHz measurement bandwidth Dynamic Range (NR Out: +/-15dB range) >108dB, unweighted THD+Noise <0.04%, 0.02% typical at +4dBu, 1kHz Interchannel Crosstalk <-80dB, 20Hz to 20kHz Noise Reduction Up to 20dB of dynamic broadband noise reduction NR Switch Activates dbx Type III Noise Reduction Bypass Switch Bypasses the graphic equalizer section in the signal path Low cut Switch (recessed) Activates the 40Hz 18dB/octave Bessel high-pass filter Range Switch (recessed) Selects either +/- 6dB or +/- 15dB slider boost/cut range I/O Meter 4-LED bar graph (Green, Green, Yellow, Red) at -10, 0, +10, and +18dBu Gain Reduction Meter 4-LED bar graph (all Red) at 0, 3, 6, and 10dB Indicators NR Active (Yellow); EQ Bypass (Red); Clip (Red); Low Cut (Red); +/-6dB (Yellow); +/-15dB (Red) Operating Voltage 100VAC 50/60Hz; 120VAC 60Hz; 230VAC 50/60Hz Power Consumption 28W Power Connector IEC receptacle Dimensions 5.25" H X 19" W X 7.9" D (13.335cm x 48.3cm x 20.1cm)